Ceiling installation of a microwave sensor switch body microwave sensor switch, the microwave sensor switch for active sensors, sensors, launch the high-frequency electromagnetic waves (5.8GHz) and receive their net change within this sensor to detect the echo is even true tiny mobile detection range did not, then the microprocessor trigger "point of light instruction signal through the doors, glass and thin walls are likely to be detected, 

 Note: The person or object toward the detection results when the sensor moves! 
 Note: this high-frequency output of the sensor is less than 10mW, just phone or microwave transmission power of the 100 one. 

 Microwave sensor switch, ceiling microwave sensor switch installation steps: 

 A counterclockwise rotation of the top cover and remove it (see FIG. 1) Open the two screws fixed in the cover (see FIG.2); 

 2, the base of the top drill mark on the wall to do, pay attention to the lead on the wall; 

 3, drilling, plastic expansion of the body to knock a hole; 

 4, the power cord through the base; 

 5, using the mounting screws to secure the base in the selected installation location (see FIG.3) 

 Identified according to the wiring of the power cord and load cord to the terminal; 

 7, close the cover, tighten the screws (see FIG.3); and then adjust the knob to set; 

 8, clockwise tighten the cover (see FIG.3). 



 Technical parameters of the TR-804 microwave sensor switch 

 Voltage: 220 ~~ 240V-100-130V- 

 Frequency: 50/60Hz 

 Installation: indoor, ceiling installation 

 HF systems: 5.8GHzCW cable, 15M band 

 Transmit power: less than 10mW 

 Load power: 800W (220-240V) 

 600W (100-130V) 

 Detection angle: 360 degrees 

 Distance of 1-8m (radius) adjustable 

 Time Delay: 8 seconds to 12 minutes 

 Light control illumination: 2 ~ 2000LUX 

 Power consumption: 0.9W nearly 



 Microwave sensor switch detection range of settings: 


 This range to be installed at a height of 2.5 meters on the ground the approximate circle radius of the area of ??detection, counter-clockwise rotation in the end detection distance (approximately 1 m radius), clockwise in the end when the detection range (approximately 8 m radius ). Note: this detection range of values ??is out of body measurements from 1.6 to 1.7 m height, medium body, and the walking speed of 1.0 to 1.5 m / sec. If the human body height, body shape, and walking speed changes, the induction distance will also change. 



 Range can be set in 8 seconds (counter-clockwise rotation in the end) to 12 minutes (clockwise rotation in the end), to detect the end of this time will be the mobile signal re-timing, it is recommended to choose the shortest time to adjust the detection range or walking test . Note: After lights out, nearly one second that it can re-induction. Only after the end of this time to detect the signal lights will be bright. 



 Working illuminance values ??can be adjusted within the range of 2 ~ 2000LUX. Counterclockwise rotation in the end, the illumination value of about 2LUX clockwise rotation in the end illumination value is approximately 2000LUX. Daytime walk test or adjust the detection zone must be this knob clockwise to the end. 



 Note: in the regulation of three functional knob, do not force too much, because the three knobs are mounted directly on the component! Adjust the beginning to the end, internal components have a small stopper, when you operate the force is too large will damage limit device, resulting in adjust unobstructed while the 360-degree rotation. Regulation limit of 270 degrees, you should be careful.